Honeywell Series 3 DC311S
$30.99
Description
Doorbell, Wireless Doorbell, White, Nameplate
Honeywell Series 3 DC311S properties
Product name | Series 3 DC311S |
Type | Doorbell |
Dorbell | Wireless Doorbell |
Colour | White |
Number of Ringtones | 4 pcs |
Lighting in Push Button | Yes |
Nameplate | Yes |
Range Wireless Transmitter | 150 m |
Max Volume | 80 dB |
Adjustable Volume | Yes |
Height | 11.0 cm |
Width | 7.0 cm |
Depth | 4.25 cm |
Weight | 193.0 g |
Frequently Asked Questions:
How do I properly install the Honeywell Series 3 DC311S electrical accessory in my home?
Here's a step-by-step guide on how to install the Honeywell Series 3 DC311S electrical accessory:
Materials needed:
- Honeywell Series 3 DC311S electrical accessory
- Wire strippers
- Voltage tester
- Screwdrivers (flathead and Phillips)
Instructions:
1. Turn off the power supply to the electrical outlet or switch where you'll be installing the Honeywell Series 3 DC311S electrical accessory. You can do this by flipping the circuit breaker or removing the fuse corresponding to the circuit that powers the outlet or switch. Remove the existing cover plate from the outlet or switch using a screwdriver. Depending on the type of screws used, you may need a flathead or Phillips screwdriver. Carefully remove the wiring connections from the terminals of the old outlet or switch. Use wire strippers to expose the ends of the wires by about ⅜ inch. Take note of how the wires are connected (e. Connect the wires of the Honeywell Series 3 DC311S electrical accessory to the corresponding terminals using wire nuts. Make sure to securely twist and tightly squeeze each wire nut in place, without twisting or stripping the wires. Refer to the wiring diagram included in the product manual for guidance on how to connect the wires. Mount the Honeywell Series 3 DC311S electrical accessory onto the electrical box using the provided screws and a Phillips screwdriver. Make sure to align the mounting tabs with the corresponding slots on the electrical box, then securely tighten the screws. Install the new cover plate over the Honeywell Series 3 DC311S electrical accessory, making sure it's flush and level with the wall surface. Securely fasten the cover plate onto the electrical box using screws and a Phillips screwdriver. Turn on the power supply to the circuit you just installed the Honeywell Series 3 DC311S electrical accessory in, then test it using a voltage tester. The voltage tester should not show any electrical current passing through the outlet or switch when plugged into an appliance or turned on with a switch. Finally, check that the Honeywell Series 3 DC311S electrical accessory is working properly by turning it on and off using the switch or plugging in an appliance to the outlet. Make sure there are no unusual sounds, smells, or visual signs of electrical problems. Note: If you're not confident in your DIY abilities, it's recommended that you hire a licensed electrician to install this product. Electrical work can be dangerous if done incorrectly, and could result in serious injury or property damage.
Reviews
There are no reviews yet.